Aubrey, TX Heating & Air Conditioner Repair, Installation & Maintenance

I repaired an American Standard heat pump in Aubrey today. The system wasn’t heating properly due to a failed defrost board. Replaced the defective part and checked the refrigerant levels. After running diagnostics, the heat pump was back to full operation, providing efficient heating once again.

In Aubrey, TX, I repaired a Trane XR95 gas furnace that was not igniting properly. I replaced a faulty igniter with an OEM part, cleaned the flame sensor, and inspected the burners for buildup. After testing, the system was operating efficiently and safely for reliable heating.

Performed maintenance on Lennox XP19 heat pump system in Aubrey, TX. Found condenser coil heavily soiled, reducing efficiency. Thoroughly cleaned coil using foaming coil cleaner and low-pressure wash. Tested electrical components, determining voltage enhancement module was faulty. Replaced failed enhancement module to restore proper voltage and amperage readings. Checked refrigerant charge, airflow, and all safety controls. Lubricated fan motor. Calibrated thermostat. Verified system operation across all modes. Improvements to condenser cleanliness and electrical components enhanced the heat pump's performance and energy efficiency.

Today, I performed routine fall HVAC maintenance on a Trane XR15 system to prepare it for the upcoming colder months. I began by inspecting the heat exchanger for any cracks or signs of wear, then checked the blower motor and lubricated the bearings. I replaced the air filter with a new MERV 8 filter to ensure good airflow and improve indoor air quality. Additionally, I tested the thermostat and inspected the flue pipe to make sure the system was properly venting. After conducting a complete system test, I confirmed the HVAC unit is ready for efficient heating this winter.

I completed a ductwork repair for a customer who was experiencing reduced airflow in their home. After inspecting the duct system, I found several leaks and gaps in the duct joints, which were causing significant air loss. I sealed the leaks using mastic sealant and reinforced the connections with aluminum tape for added durability. I also wrapped sections of the ductwork with R-8 insulation to improve energy efficiency and reduce future air loss. After the repairs, I performed a pressure test to confirm that the system was now sealed. The home’s airflow is restored, and the HVAC system is running more efficiently.

I diagnosed and repaired a faulty Copeland scroll compressor in a Carrier 24ABC6 central air conditioner. After testing the capacitor and contactor, I found a refrigerant leak in the evaporator coil. I sealed the leak using Rectorseal AC Leak Freeze, recharged the system with R-410A refrigerant, and replaced the filter drier. The unit now operates at peak efficiency.

I serviced a Mitsubishi MXZ-3C30NAHZ2 multi-zone heat pump that was experiencing poor cooling performance. Diagnostics revealed low refrigerant levels and a malfunctioning expansion valve. I located and repaired a small refrigerant leak at a flare connection using Nylog Blue thread sealant, then recharged the system with R-410A to the correct levels. I also replaced the faulty expansion valve. After these repairs, I recalibrated the system and confirmed proper operation in both cooling and heating modes.

Performed comprehensive repair and maintenance on a Lennox Elite Series XC20 AC unit. Addressed a refrigerant leak and recharged the system with R-410A. Replaced a faulty capacitor and cleaned the condenser and evaporator coils to enhance efficiency. Checked all electrical connections and ensured the thermostat was functioning correctly. Regular maintenance helps prevent breakdowns and extends the lifespan of your AC unit. For expert AC repair and maintenance, contact us for professional and reliable HVAC services.

Completed an AC repair on a Goodman GSX16 unit. Diagnosed a failing capacitor and replaced it with a Goodman OEM capacitor to restore proper function. Inspected refrigerant levels and added R-410A refrigerant to ensure efficient cooling. Cleaned the evaporator and condenser coils to improve airflow and system performance. Regular maintenance and timely repairs are essential for extending the life of your AC unit. For expert AC repair services, contact us for professional and reliable HVAC solutions.

Completed an air duct service to improve HVAC efficiency and indoor air quality. Inspected the entire duct system for leaks and damage, sealing any identified issues. Cleaned all ducts thoroughly to remove dust, debris, and allergens using a high-powered vacuum and brush system. Checked and cleaned the vents and registers to ensure unobstructed airflow. Verified proper system operation post-cleaning. The air duct service has enhanced airflow, system efficiency, and overall air quality in the home.

I performed an HVAC repair on a Trane system. The unit had a malfunctioning capacitor, which I replaced with a new OEM part. I also checked the refrigerant levels and topped off with R-410A as needed. After inspecting the blower motor and cleaning the coils, I tested the system to ensure it was operating efficiently.

Today in Aubrey, TX, I addressed a noisy AC unit by replacing its malfunctioning blower motor and worn belt. I used a Honeywell replacement motor and a standard HVAC belt. After installation, I tested the unit for operational sound levels and airflow efficiency, ensuring the repair resolved the noise issue and restored quiet, effective cooling to the home.

Mini split

Performed comprehensive maintenance and safety inspection on a Lennox SLP98V furnace in Aubrey, TX. Inspected electrical components, replaced filters, and ensured proper ventilation. Verified safe operation and efficiency for optimal heating performance, prioritizing the comfort and safety of the homeowner's environment.

Installed a new Bryant Evolution 987M furnace in Aubrey, TX. This high-efficiency model offers advanced features like variable-speed operation and quiet performance. Enhancing comfort and energy savings, it ensures reliable heating for residents in Aubrey, TX.

Installed a Carrier Infinity 25VNA8 heat pump in Aubrey, TX. This model offers variable-speed operation for precise temperature control and enhanced energy efficiency. With Greenspeed® Intelligence, it adapts to changing conditions.

I did a wire repair on a rheem indoor unit. Aubrey Tx.

Uv light install and high filtration system

Heat maintenance

No heat

Heat maintenance and repair

Client would like to sell home and AC and heating were both in need of service. Electric Furnace Repair - blower replaced and wiring updated/repaired. AC Services and system was badly in need of cleaning and maintenance. All fully functioning now.

Furnace Repair - Malfunctioning blower motor preventing the distribution of warm air throughout home. Repair completed and all rooms are warming again.

Furnace Repair - No heat. Upon diagnostic completion found that Heating was not getting power. Furnace fixed and currently running.

Today in Aubrey, TX I had an ACIQ heat pump installation. The installation involved positioning and securing the heat pump unit, connecting refrigerant lines, and ensuring seamless integration with existing HVAC components. Reviewed all electrical connections to guarantee safe and reliable operation. Performed a thorough system test to validate functionality and efficiency. Your new ACIQ heat pump ensures year-round comfort with its advanced features.