Krugerville, TX Heating & AC Repair, Installation and HVAC Service

Heat membership. I checked all electrical,mechanical,and performance systems Aubrey Tx

I performed a heater tune-up in Krugerville and inspected the heat exchanger for cracks or corrosion. Using a combustion analyzer, I confirmed safe levels of carbon monoxide and ensured no leaks. The system passed inspection and is operating safely.

Performed a heat maintenance service as part of a membership plan on a Rheem gas furnace in Aubrey, TX. I inspected and cleaned the burners to ensure proper combustion, tested the flame sensor for reliable ignition, and checked the heat exchanger for cracks or signs of corrosion. The blower motor was inspected for wear, and I lubricated all moving parts where applicable. I also tested the thermostat's communication with the furnace and verified proper cycling. The air filter was replaced to improve airflow, and the gas pressure was adjusted to manufacturer specifications for optimal performance. Lastly, I measured carbon monoxide levels to confirm safe operation. The system is now operating efficiently and safely.

Just resolved a defrost cycle issue on a Lennox heat pump system in Aubrey. Diagnosed failed defrost control board and faulty temperature sensor causing incomplete defrost cycles. Replaced the original Y7761 control board with updated model and installed new 10K outdoor coil temperature sensor. System now properly entering defrost cycle at 31°F with correct timing sequence. Heat pump operating at full efficiency. Available for heat pump diagnostics and repairs throughout the Denton County area. Licensed and insured professional.

I diagnosed and repaired a noise issue on an American Standard HVAC system in Denton County. Investigation revealed a loose blower wheel causing vibration against the housing and worn belt creating a squealing sound. Performed complete blower assembly inspection, tightened mounting bolts to factory specs, and replaced worn drive belts. Also lubricated all bearings and checked motor mounts. The system is now running whisper-quiet. Available for diagnostic services across Denton County. Licensed and insured!

Troubleshot a Nest Learning Thermostat that was not communicating with the furnace. Found a faulty C-wire connection. Repaired the wiring, reset the thermostat, and confirmed normal operation by testing heat and cooling modes.

Repaired a Goodman GMEC96 furnace that failed to ignite. The issue was traced to a defective igniter. Replaced the igniter with an OEM part and verified proper combustion by measuring the flue gas output using a combustion analyzer.

Replaced an old gas furnace with a high-efficiency unit. Disconnected the existing system and removed it carefully. Installed the new furnace, connected the gas lines, and tested for leaks using a gas leak detector. Completed duct sealing and thermostat setup.

I repaired an Rheem air conditioner in Krugerville today that wasn’t cooling. The issue was a clogged drain line. After clearing the line, I checked the evaporator coil for dirt and cleaned it. The AC is now running efficiently, providing consistent cooling.

We found a fault on the outdoor trane circuit board. Pilot point tx