Sanger, TX HVAC Services

Repaired a leaking duct plenum with several gaps around collar connections. Used mastic and mesh tape to seal joints and reinsulated the outer surface. Verified airflow improvements at two supply vents using an anemometer. Reduced conditioned air loss significantly in this zone.

Installed a Pure AirX UV light in an air handler that had visible signs of mold growth. First, I cleaned the evaporator coil and sanitized the blower compartment. Then, I mounted the Pure AirX UV lamp for continuous disinfection and added drain pan tablets for microbial prevention. System is now equipped to maintain cleaner air and protect indoor air quality year-round.

Conducted an AC tune-up for a 2.5-ton unit. Cleaned both indoor and outdoor coils, tightened high-voltage wiring, and flushed the condensate drain. Tested capacitor and contactor under load. System was running slightly high on head pressure, so I cleaned the coil again and saw improved readings. Overall, unit performance is solid for summer operation.

Responded to a no-cool call and found a clogged TXV restricting refrigerant flow. Recovered refrigerant, replaced the valve, pulled a vacuum to 500 microns, and recharged with R-410A. Verified superheat and subcooling were in spec. Unit is now cooling at full capacity with stabilized suction pressure.

Responded to an emergency no-cool call. Found a failed contactor preventing compressor operation. Replaced contactor, verified voltage, and restored full function. AC cooling the home properly again.

Customer experiencing high energy bills. Conducted a full system performance check. Found a dirty condenser coil reducing efficiency. Performed coil cleaning—system now running at optimal efficiency.

Found a blower motor pulling high amps, indicating wear. Recommended proactive replacement before failure. Customer approved, installed new motor, and tested airflow—running efficiently again.

Installed a new Carrier 25VNA8 high-efficiency air conditioning system with Performance Boost two-stage compressor and Infinity communicating control board. Replaced existing air handler with Carrier FV4C N08 variable-speed ECM furnace. Ran new refrigerant lineset of 3/8" liquid and 7/8" suction lines using Webstone LineSet Cover. Fabricated new plenum transitions for existing ductwork using Stamford Shortbody elbows. Evacuated to 500 microns using a Fieldpiece EVAC4WAY vacuum pump. Charged with Carrier-supplied R-410A refrigerant per data plate. Installed new programmable Infinity Zone Control wifi thermostat and enabled ComfortHeat Staging to maximize efficiency.

No heat

Worked on a zoning system. We found a comfort control circuit, not working correctly replaced it and did a performance test Sanger Texas.

Went out to a residential home to provide an indoor air quality assessment. Cleaned the home's air ducts as well. Customer decided on installing an air purifier so we scheduled a future appointment. The customer is looking forward to having better air quality in their home.

Went out to service a residential customer's air conditioning system. Looked over the whole unit to see if there were any issues. Removed debris from the system and replaced the filters. The cooling system is now performing optimally for the customer.

Customer called us to see if we could test their home's air quality. Went out and performed testing at the home. Looked over the results with the customer and talked through what would be best to improve the air quality issues. Made a plan to install new filters and air purifiers. Scheduled a future appointment for installation.

Customer called us to see if we could test their home's air quality. Went out and performed testing at the home. Looked over the results with the customer and talked through what would be best to improve the air quality issues. Made a plan to install new filters and air purifiers. Scheduled a future appointment for installation.

Customer called us to see if we could test their home's air quality. Went out and performed testing at the home. Looked over the results with the customer and talked through what would be best to improve the air quality issues. Made a plan to install new filters and air purifiers. Scheduled a future appointment for installation.

Customer called us to see if we could test their home's air quality. Went out and performed testing at the home. Looked over the results with the customer and talked through what would be best to improve the air quality issues. Made a plan to install new filters and air purifiers. Scheduled a future appointment for installation.

Air Conditioning Repair near Houston St. Arrived at the client’s home to perform repairs on their a/c system. Discovered the damper motor on the unit was damaged. Replaced the damper motor to restore service to the client’s a/c system.

Air Conditioning Repair near Houston St. Arrived at the client’s home to perform repairs on their a/c system. Discovered the damper motor on the unit was damaged. Replaced the damper motor to restore service to the client’s a/c system.

Air Conditioning Repair near Houston St. Arrived at the client’s home to perform repairs on their a/c system. Discovered the damper motor on the unit was damaged. Replaced the damper motor to restore service to the client’s a/c system.

Air Conditioning Repair near Houston St. Arrived at the client’s home to perform repairs on their a/c system. Discovered the damper motor on the unit was damaged. Replaced the damper motor to restore service to the client’s a/c system.

Air Duct Cleaning near Eider Dr. When our client called us about the quality of the air in their home, we recommended duct cleaning to reduce the dust in the air. I arrived at the home to perform the duct cleaning for the client. Cleared the dust and debris from the ducting throughout the home. The amount of dust was noticeably reduced upon departure and the client was grateful for the service.

Air Duct Cleaning near Eider Dr. When our client called us about the quality of the air in their home, we recommended duct cleaning to reduce the dust in the air. I arrived at the home to perform the duct cleaning for the client. Cleared the dust and debris from the ducting throughout the home. The amount of dust was noticeably reduced upon departure and the client was grateful for the service.

Air Duct Cleaning near Eider Dr. When our client called us about the quality of the air in their home, we recommended duct cleaning to reduce the dust in the air. I arrived at the home to perform the duct cleaning for the client. Cleared the dust and debris from the ducting throughout the home. The amount of dust was noticeably reduced upon departure and the client was grateful for the service.

Air Duct Cleaning near Eider Dr. When our client called us about the quality of the air in their home, we recommended duct cleaning to reduce the dust in the air. I arrived at the home to perform the duct cleaning for the client. Cleared the dust and debris from the ducting throughout the home. The amount of dust was noticeably reduced upon departure and the client was grateful for the service.

Air Conditioning Installation near Sandpiper Ln. I arrived at the home to install a new Lennox air conditioning system. It was successfully installed and I tested all components for quality assurance. The new system is working wonderfully to cool the home before the summer heat arrives.